Physics Quizzes Stage-9

Here you’ll find the most important and repeated Physics past paper questions Quizzes Stage-9. A perfect way to prepare for top competitive exams and score maximum marks. Good Luck
 
  • Total Quizzes: 30
     Total Marks: 30
    Total Questions: 30
    Time Allowed: 10 minutes
    The correct answers will be displayed after the test is completed.
 
Start Test

Result

Congratulations! You shine because you dared to work hard when it was tough. Keep glowing!

Fail! No worries — rise, revise, and return stronger!

#1. The impact strength of a material is an index of its _____?

#2. Impulse gives a measure of the product of _______?

#3. The point on the stress-strain curve at which the cross-sectional area of the test specimen starts decreasing is called the _____?

#4. Cast iron is ______?

#5. Toughness of a material signifies _____?

#6. Identify the pair which has same dimensions?

#7. Pick up the material with highest ductility?

#8. Silicon in cast iron ______?

#9. Rivets are generally specified by ______?

#10. Quartz is a ______ material.

#11. First Law of motion gives the definition of _____?

#12. The area under the stress-strain curve represents _____?

#13. Iron has the unique characteristic of being ______?

#14. In carbon steel, the presence of small quantities of sulphur improves ____?

#15. For a floating body, the line of action of a buoyant force acts through _____?

#16. For wire drawing operation, the work material should be _____?

#17. Which of the following is a dimensional quantity?

#18. The slag from the blast furnace consists of ______?

#19. The maximum bending moment in a simply supported beam carrying two unequal concentrated loads occurs ______?

#20. Process used for casting gas turbine blades is ______?

#21. The Moment of inertia (MOI) of a body does not depend upon _____?

#22. The tendency of a material to fracture without appreciable deformation is called ____?

#23. Measure of the effect of compressibility in fluid flow is the magnitude of a dimensionless parameter known as ______?

#24. During flood, water entered an office having wooden tables. Indicate the position of tables, if floating ______?

#25. Steel can be hardened quickly by the process of ______?

#26. The combined effect of slip and creep should not exceed ____?

#27. Modulus of elasticity is defined as the ratio of _____?

#28. Which one of the following surfaces in contact has minimum coefficient of friction?

#29. Addition of sulphur to steel increases its ______?

#30. The apparent weight of a man in a lift is less than the real weight when the lift is going down ______?

Previous
Finish

Leave a Reply

Your email address will not be published. Required fields are marked *